Flight Path - iFly Owners Q&A - iFly EFB

iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly Owners Q&AiFly Owners Q&AFlight PathFlight Path
Previous
 
Next
New Post
2/26/2021 1:01 PM
 

I noticed that one can run a finger along a flight path and get distances to/from both waypoints in NM; my Piper is calibrated in SM.  Is it possible to get these distances to display in SM?  I had already chosen SM under "Units".

 
New Post
2/26/2021 4:30 PM
 

Unless you're getting a different behavior on your iFly unit than I am on my tablet or phone, you're actually rubber-banding the flight plan leg to some degree and that's what's giving you the distances from each of the two waypoints. 

Yes, it does it give in nautical miles, but I highly agree that if the default is set to statute miles then that's what should be shown.


Powrachute PC 2000; Aventura II; Cherokee 180
 
New Post
3/1/2021 4:28 PM
 

Hook is right in his assupmtion here - that's 1000% what it sounds like you're doing. 

Verify you're in the correct units by going to menu/setup/units of measure and changing length measurements how you see fit. 

 
New Post
3/1/2021 8:49 PM
 

I can confirm that my setting for mileage is also in Statute Miles, and when I rubber band a flight leg it gives the measurements in Nautical Miles.  It really should use what the user has selected.


Powrachute PC 2000; Aventura II; Cherokee 180
 
New Post
3/8/2021 3:29 PM
 

Kicked this up

 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly Owners Q&AiFly Owners Q&AFlight PathFlight Path