NMEA and Skyradar Issues - iFly Owners Q&A - iFly EFB

iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly Owners Q&AiFly Owners Q&ANMEA and Skyradar IssuesNMEA and Skyradar Issues
Previous
 
Next
New Post
2/23/2012 5:14 PM
 
David wrote:

Hi Walter,

I just installed 6.5.7 and I'm sorry to report that, at least on my trusty '700, the data output cycles on and off about every 20 seconds and is therefore useless. Even when it cycles on the course information is missing most of the time. I then rebooted with 6.0.8 and as usual everything is OK with the NMEA output.

David

David, try 6.5.9 - fixed that problem.

-Walter


Walter Boyd
President, Adventure Pilot
 
New Post
2/23/2012 5:16 PM
 

Alasdair, try the new beta version I just put up - I'm hopeful it will correct your NMEA problem.


Walter Boyd
President, Adventure Pilot
 
New Post
2/23/2012 5:32 PM
 

Roger that, it's already downloaded! I'll give it a try tomorrow.

Thanks Walter,

David


C177RG: iFly 720, Stratux 978/1090 ADS-B in, AHRS, BMP, Stratus ESG ADS-B out. RV-3: 8" Samsung Tab A, Stratux 978/1090 ADS-B in, AHRS, BMP, Stratus ESG ADS-B out.
 
New Post
2/24/2012 11:38 AM
 

Hi Walter,

I just gave 6.5.9 a try, and again no joy with my '700. The behavior was the same as before with 6.5.8, the data output cycling on and off about every 20 to 30 seconds, with no course info.

David


C177RG: iFly 720, Stratux 978/1090 ADS-B in, AHRS, BMP, Stratus ESG ADS-B out. RV-3: 8" Samsung Tab A, Stratux 978/1090 ADS-B in, AHRS, BMP, Stratus ESG ADS-B out.
 
New Post
2/24/2012 1:28 PM
 

David,

Very strange. The code for handling NMEA output for the 700 is almost identical between 6.0.8 and 6.5.9. And we've been running this without fail in our test jig for several hours. Couple of questions: What is your OS version? (System Menu / Config / System...then read the number next to "OS"). Also, when you switch back to 6.0.8 are you swaping out the SD card? If so, there's a chance the settings are different - please verify your NMEA settings are the same in both versions. Finally, what do you have selected in the "Load Prolific Drivers at Startup" option? Can you try changing that setting and rebooting your device?

Thanks,
Walter


Walter Boyd
President, Adventure Pilot
 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly Owners Q&AiFly Owners Q&ANMEA and Skyradar IssuesNMEA and Skyradar Issues